Tag Archives: Blower Resistor

Blower motor resistors can cause the fan to not work on some speeds in your car or truck. Read common problems and answers.


2002 Chevrolet Malibu Transmission Codes and Blower Speed Problem

I had my 2002 Chevrolet Malibu serviced at non-Gm transmission shop which scanned the computer for codes. They found P0741 & P0730 which are TCC clutch related. I had them test drive the car to make sure it was not an intermittent problem which could be repaired other than the recommended re-flash of the PCM their service department suggested. They said the transmission wasn’t going into overdrive, so they flashed the computer. We…

Continue reading


Buick Lesabre Blower Motor Only Has High And Low Speeds

2000 Buick Lesabre. My blower has only been working on low and high for a while, nothing in between, and i do not have power to the resistor on any settings except low and high, but now my blower does not work at all and the cruise light is on, sometimes if I’m playing with the control head changing speeds the cruise light will flicker.…

Continue reading


1999 Olds Alero Blower Motor and Security Light

I have a 1999 Oldsmobile Alero. The blower motor does not work. I have replaced the blower motor with a delphi motor and the blower motor resistor 3 times. The blower worked one time and has quit again. ProTech: Are you sure you don’t have a wiring problem somewhere? Where do i start to look for the problem. You might want look for water intrusion…

Continue reading


Some Blower Motor Fan Speeds Not Working

This one has been a big issue over the years. Many, many times a car or truck will come into the shop with the customer complaining that their blower motor doesn’t work, or only works on high speed, etc. This is usually the case after a blower resistor failure on one or more speed settings. What is happening to them you ask? Well, the resistor…

Continue reading


2005 Chevy Equinox Blower Motor Speed Problems

2005 Chevrolet Equinox, starts up but when I put it in gear, it is in overdrive. Turn it off then restart it, it works fine for a while, then does the same thing again at a stop sign or light. Mechanic JK: what makes you think it is in overdrive? That’s what it seems. Hit the gas and it is like a slipping clutch(auto) until…

Continue reading