- February 23, 2016 at 10:53 pm #12933
I have a 99 Malibu that cranks but won’t start. I went to the store and came back and now it wont start, and the instrument cluster doesn’t light up. I checked all the fuses.
- December 23, 2018 at 12:43 am #16817
Check to see if your battery is any good. If it is, check for a bad ignition switch,
- February 23, 2016 at 10:53 pm #11250
I HAVE A 2003 MALIBU , IT HAS A 3100 THAT HAS ROD BROKE AND HOLE IN BLOCK , I HAVE A 99-2000 LONG BLOCK THAT IS REMAN, ITS NEVER BEEN INSTALLED , AND WAS GAVE TO ME FROM FRIEND , I NEED TO KNOW IF I CAN PUT IT IN MALIBU WITHOUT A LOT OF HASSELS, I HAVE A INTAKE AND THROTTLE BODY AND INJECTORS AS WELL, ANY HELP WOULD GREATLY APPRECIATED THANK YOU .
RE: It should match right up, there weren’t many differences between those years of the 3100 engines. Just make sure to swap everything over, including sensors, wiring harnesses, etc. Should be an easy exchange.
- March 13, 2016 at 9:10 pm #12937
I have replaced the turn signal switch and I still have no turn signals. Hazards work but nothing else. Fuses all look good.
2003 Chevy Malibu
Replace the hazard switch, it is also the flasher for the turn signals and there have been many known problems with them. You might want to check with your local GM dealer, as there may even be a recall on the hazard switch which then you could get replaced for free.
- December 23, 2018 at 12:45 am #16818
Yes, the turn signal switch is very common to cause the problem with the lights.
- February 16, 2017 at 2:06 pm #15024
misfire #1 cylinder. Blown head gasket, and warped head. Exhaust valve burnt. After new seals, and valves, and head, does there need to be any compression checks. also the EGR valve was not replaced, and was leaking.
- February 18, 2017 at 9:41 pm #15048
You do not need to do any compression or cylinder leak down checks unless you just want to confirm that the job was done correctly. If you mean that after this work, the engine now has a misfire on #1 cylinder, then yes I would do these test. But also check the basics- spark, injector pulse.